How to check for roof leaks?

How to check for roof leaks?

Annoyed of the leaky roof? Well, you’re not alone as roof leaks are quite common. However, there’re few things in life more frustrating and inconvenient than a leaky roof. The best way to track down the leak is by thinking like water because at times leaky roof detection can be deceiving. Water stains that you may see on the roof may not necessarily be where the leak is located.

But you must find the source of the roof leak and plug it immediately to avoid more costly repairs in the long run. So, if you suspect that the roof is leaking, act immediately before it gets any worse.

So, to help you out, we’ve laid out a foolproof plan, in this guide, to check the source of your leaky roof.    

How to check the source of a leaky roof?

Look at the underside of the roof

Whenever you’re after a leak, be sure to start from the obvious sign like a wet patch or dripping crack but never consider that soaking spot as the main cause of a leak. The water entering your house at one of the roofs can trickle down through insulation and plasterboard before soaking into the weak spot of your ceiling.

Look for penetrating Items of your roof

The first thing to watch out for is any item that is penetrating your roof because they are by far the most common source of leaks. Things like plumbing, roof vents, and chimneys can be a near or around that leak. Anyhow, the best way to track down the leak is by going up to the attic. So, take the flashlight and go up there to look for any evidence of a leak. If you find water stains, black marks, or signs of mold up there that’s the tell-tale signs of a leaking roof to watch out for.  

Look on the exterior part of the roof

The next step is to walk outside and visually inspect your roof. But be sure to follow all the safety protocols while stepping up there as you’d never want to tip over. You must inspect the parts of the roof that are higher than the location of the inside stains or see if there are any obvious signs of penetrations. If you can spot any damaged areas around the roof tiles, corrugated iron sheet, or shingles, this might be the location of the leak.

Check the exterior walls

You can also look on the exterior walls under the roofline for water spots. If there are any, this could be a sign that your flashing is damaged and needs to be repaired or replaced.

Now that you’ve found the main reason for your leaky roof the next step is to apply sealant or compound on the leak. You can use quick-drying silicone-based sealant or you can fix sheet or metal or replace flashing for a damaged roof tile or shingle. Similarly, if you have any drains and gutters plug issue make sure to clear out the debris and repair bad sections to avoid water damage.

Time to call experts

Looking for roof repair in Buford? Look no further because as a roofing expert in Burford we’re a name you can trust. We’ve been helping our clients with our investigative instincts for years. So, call us now and our team is always there to discuss a way out.   

 

Leave a Reply

Your email address will not be published. Required fields are marked *